DENARE WATERPROOFING TECHNOLOGIES AUSTRALIA Material Polypropylene (uv-stabilised) Colour Black Weight 110g (without chocks) 140g (with chocks) Diameter 162mm Base Area 200 sq.cm Height 40mm Adjustable Height 24 to 35mm Marginal Adjustments 1.0mm Width of Spacer 4mm Max.Load 600kg (per support) 2,400 kg (total) Boilogical resistance Unaffected by moulds and algae Chemical resistance Good resistance to oils, acids, alkalis and bitumen Flammability Does not support combustion Serviceable temperature -30°C to 120°C Guarantee/Warranty VersiPave are warranted to be free of defects and are guaranteed to meet the specification standards detailed in the "Summary of Properties" table. Any product shown to be defective when applied in accordance with recommended installation procedures will be replaced at no charge. Product defect claims must be made in writing and received within 6 months from the date of shipment of goods. Quality Improvements Elmich (Far East) Pte Ltd is dedicated to improving the performance of VersiPave adjustable paver supports to meet specifications and requirements laid down in relative building standards.Any such changes will not be detrimental to the specifications detailed herein Versipave®   Side view showing Versipave® with a chock positioned on a support. Maximum Load Versipave® are able to withstand a maximum load of 2.4 tonnes when tested in accordance with ASTM 395 (modified). Durability Versipave® have excellent durability as they are positioned beneath the paving slabs and hence, are protected against direct weathering. Easy to Install • Measure the total area to be paved to determine the number of pavers and Versipave® required. • Mark the intersections of the corners of each paver to be laid on the substrate. • Pack up to levelling line with bricks or pavers placed on the position where the Versipave® units are to be located, if the substrate has a slope greater than that which cannot be taken up with chocks. • Where free edges and corners are to be suported, break the Versipave® along the quadrant line. • Lay out Versipave® units in the positions marked out on the surface to be paved. • Place the pavers into place on each Versipave® and simply adjust the chocks on the supports to ensure each paver is level. Quantity Required This may be estimated on the basis of one Versipave® unit is required per slab or paver to be supported. Packaging Versipave® are supplied in a carton of 50 with 200 chocks included in each carton. << BACK